NETWORK WIRE SPLICE CONNECTOR CRACKED

ATT said it would take a month to get the wires repaired. A few months ago I finally got audible static on the line, so the repair guy kept digging to find trouble, he measured a significant signal drop, found corroded connections at the pole that were so bad some fell apart when he started to work on them.ĭaughter signed up for DSL, found out her landline had been damaged during some road repair work. One summer it was very hot, and no rain for months, during which DSL worked fine. I even had then split me off a seperate jack at the side of the house box just for DSL, which I ran a new wire 10 feet to my modem. I'd been through several computers & modems over the years, no change. ATT claimed it was my computer / modem / house wires, anything but their system. At least they put tape on your wires, mine just wrapped the wire around the pole so he didn't have to cut the line shorter and didn't secure it to the pole properly. He wasn't even going to check the entirety of the line from house to pole! I badgered him until he got his ladder and turned out the line had been installed so that it was wrapped around the pole and rubbing in the wind, wearing off the insulation.

The tech came out and said that the connection one the outside wall of the house is fine. I told them that it's not raining inside my house, send a tech anyway. I called for a technician to come out, they did a ping from there and they said my modem was failing. A few years later, my dsl is going out every morning when it's foggy/misty or raining, wouldn't come back on for hours. My phone company 'repaired' my phone line coming off the pole behind my house a few years ago after a hurricane knocked it off the pole.

| Summon: wikibot, what is something? | flag for glitch Will also delete if comment's score is -1 or less. Differential pairs are usually found on a printed circuit board, in cables (twisted-pair cables, ribbon cables), and in connectors.Ībout | /u/SSChicken can reply with 'delete'. The opposite technique is called single-ended signaling. The technique can be used for both analog signaling, as in balanced audio, and digital signaling, as in RS-422, RS-485, Ethernet over twisted pair, PCI Express, DisplayPort, HDMI, and USB. Since external interference tend to affect both wires together, and information is sent only by the difference between the wires, the technique improves resistance to electromagnetic noise compared with use of only one wire and an un-paired reference (ground). Here's a bit from linked Wikipedia article about Differential signalling :ĭifferential signaling is a method of transmitting information electrically with two complementary signals sent on two paired wires, called a differential pair.

You and /r/techsupport.įurther subreddits of interest: /r/talesfromtechsupport /r/technology /r/techsupportmacgyver /r/oddware /r/algoreTechSupport Subreddits You May Like r/techsupportgore will not pay for your psychiatrist/mental health care consultant after seeing our content. This is more than enough time to show what needs to be shown.Ħ) No asking for tech support. We have seen them, they used to be funny, now they're not.ĥ) No videos over 30 seconds. Error messages, infection counts, etc., do not constitute 'gore'.Ĥ) Your post actually has to be tech gore! This includes stock photos.

NETWORK WIRE SPLICE CONNECTOR CRACKED

1) No posts with just cracked screens! If that device/phone has more than a cracked screen, then post it.Ģ) No posts about just dusty computers, they are rarely cringeworthy! Dusty computer pictures should be submitted toģ) Post screenshots and software carnage to /r/softwaregore.

Network wire splice connector